Biochar obtained from recovered cellulose and its mixture with conventional sources: Assessment of its potential for the removal of pollutants in water

Yearly thousands of tons of cellulose, in the form of toilet paper, end up in the wastewater treatment plants (WWTP) through the sewage. Cellulose was recovered with a 0.35 mm sieve and processed obtaining three different pellets: pure cellulose, straw mix (50 % cellulose-50 % straw) and wood mix (50 % cellulose-50 % wood). Those materials were carbonized at 750 °C for 210 min producing non-activated biochar. Then, a part of those biochars was biologically activated by fermentation adding minerals, nutrients and a mixture of bacteria. All biochar versions were characterized, assessing the surface, porosity and adsorption capacity for a dye (indigo carmine) and a selection of 5 micropollutants (MPs): benzotriazole, carbamazepine, clarithromycin, DEET, and diclofenac. However, results showed that conventional analysis for adsorbents was not adequate for biologically activated materials since biofilm can obstruct the pores of the supporting material hindering the pollutants' adsorption. Therefore, the biological degradation of the pollutants by the microorganisms was also tested. Finally, biologically activated WOW-Biochar straw mix was the selected material to be further applied in constructed wetlands (CW) due to its higher average MPs removal capacity. Validation test at mesocosm scale demonstrates the suitability of the material as an admixture in CW, reaching a MPs removal rate higher than the 90 % regarding the WWTP inlet.