Corrosion properties of CuAl9Mn2/ER 321 composites formed by dual-wire-feed electron beam additive manufacturing

Introduction. The development of novel materials based on copper alloys and stainless steel, as well as the determination of the optimal parameters for its processing make it possible to expand the area of its implementation, increase efficiency and service life of tools and constructions. The load-bearing parts of marine equipment (bearing constructions, piston cylinders, pumps, valves, gears, rotary instruments, etc.), made of austenitic steels or aluminum bronze, are in direct contact with sea water, so the problem of increasing its corrosion resistance in the presence of strong oxidizing agents (Cl-, F- anions) is relevant. One of the advanced and actively researched methods for producing copper/steel composites is additive manufacturing that allow fabricating complex parts through layer-by-layer growth. In particular, the synthesis of composites based on aluminum bronze and steel can be realized by wire-feed electron beam additive manufacturing. In order to implement composite materials produced via additive technologies in a humid (marine) climate, it is necessary to ensure not only high strength, but also corrosion properties. The purpose of this work is to study the corrosion resistance of composites, based on aluminum bronze CuAl9Mn2 and stainless steel ER 321 produced by dual-wire-feed electron beam additive manufacturing. Research methods. Examination of the surface of CuAl9Mn2/ER 321 composites before and after corrosion tests was carried out by methods of voltammetry and electrochemical impedance spectroscopy using a potentiostat-galvanostat. Results and discussion. Using a complex of electrochemical methods, it is revealed that the developed composites with a volume fraction of steel ≥ 25% demonstrate a significant decrease in anodic current densities and a simultaneous increase in charge transfer resistance. Composites with a steel content of 75 vol. % are characterized by the highest corrosion properties in 3.5 wt. % NaCl solution, which is referred to a reduction in corrosion rate by 9.5 times compared to aluminum bronze. It is shown that the main processes occurring on the surface of the composites (CuAl9Mn2 + ER 321) are anodic oxidation of copper and iron, leading to the formation of corrosion products – Cu2O and FeCl2.