Simulation and design of a solar chimney integrated with phase change material layer for building ventilation

The development of modern life requires new energy sources, and one of this energy is renewable solar energy uses in solar chimney for natural ventilation, but at the present time it is not greatly invested, taking into account the weather conditions of the region and the physical characteristics of solar radiation and air in the area in which the study will be conducted. The current study was carried out in Basrah city- Iraq, at longitude 47.749° and latitude 30.568°, where the solar chimney was facing south. The investigation was conducted using both theoretical and experimental studied. In the theoretical study, the solar chimney with the room in the presence and absence of PCM was simulated numerically using the finite volume method using the soft package ANSYS-Fluent/2021/R2. The effect of different tilt angles (α = 30°, 45°, and 60°), solar chimney air gap (gab = 10 cm, 15 cm, and 20 cm), and PCM basin thickness ( t PCM = 3 cm, 4 cm, and 5 cm) were investigated. The results were presented in the form of contours of the distribution of streamlines, velocity, temperature, and liquid fraction of the solar chimney with the room, rate of temperature of the absorber plate with time and the rate of temperature of the PCM (T PCM ) with time, rate of air change per hour (ACH). As for the experimental side, the device was built, and the intensity of solar radiation was studied for several days on 30 Sep. and 15 Oct. 2023, the temperature distribution rate of the absorbent plate over time, the PCM temperature rate, and the air change per hour (ACH). The theoretical results were compared with the experimental results, where there was good agreement, and the theoretical comparison was also made with several researchers. Significant results showed that the optimal ratio of the air gap width of the solar chimney is 15 cm, the inclination angle of the solar chimney α = 30°, and the thickness of the PCM basin ( t PCM = 4 cm) to obtain the maximum ventilation rate. The thickness of the PCM basin = 4 cm gives the largest liquid fraction along time and maximum average temperature of the absorber plate. On the experimental, it was found that PCM convert into the liquid phase after its melting point, which is 340 K, after 12 noon, and the highest value of ACH reached 37 on September 30/2023 at midday.