Graph-Analytical Method for Calculating Settlement of a Single Pile Taking into Account Soil Slippage

Most of the existing methods of pile settlement calculation, including normative methods, do not fully take into account the processes occurring in the soil when loads are transferred to them and the changes in the properties of the contact zone soils. This leads to underutilisation of the bearing capacity of the soil, and the calculated settlement value may differ several times from the real values. In this paper, a graph-analytical solution to the problem of interaction of a single pile with a three-layer soil foundation is proposed to determine the settlement, taking into account the complex nature of the pile operation and the processes occurring in the soil when loads are transferred to them. The proposed method allows to use the non-linear behaviour of the soil on the lateral surface and under the tip of the pile, the possibility of its detachment and slippage after reaching the ultimate strength of the soil, changes in the properties of the contact zone soils, and the load distribution on the pile between its lateral surface and the tip. To verify the proposed graph-analytical solution, a comparative analysis was performed with the numerical method in the Plaxis 2d software (version 21.00.01.7) and with the results of static tests of piles at the construction site. To determine the strength reduction factor at the contact of soils with concrete, laboratory tests were carried out on a direct shear apparatus. Based on the results of the performed calculations, graphs of the dependence of settlements on loads were plotted, conclusions were drawn about the possibility of using the graph-analytical method, and prospects for further development and improvement of the graph-analytical method were proposed.