Effect of Gurney Flaps on Non-Planar Wings at Low Reynolds Number

The effect of spanwise wing non-planarity, employed in conjunction with a Gurney flap, is presented. Testing was undertaken in a low-speed wind tunnel using a rectangular wing with an aspect ratio of three. The outer one-third of the wing was non-planar, which took the form of either dihedral or a circular arc. A 2% high Gurney flap was implemented such that it could extend over the entire span or the planar inboard section. The loads were measured using a sting balance. The data show that non-planarity increases the maximum lift coefficient and the wing’s lift curve slope. Gurney flap lift modulation was enhanced in the presence of non-planarity. The addition of Gurney flaps caused a greater increment in the minimum drag coefficient for the non-planar wings. The Gurney flaps reduced the lift-dependent drag of the wings. As a whole, the Gurney flaps reduced the maximum lift-to-drag ratio (L/D)max for the non-planar wings; however, the flat wing exhibited a small L/D increment with flap addition.