An investigation into the use of incoherent UV light to augment IR nanosecond pulsed laser texturing of CFRP composites for improved adhesion

• Incoherent UV light treatment significantly enhances CFRP bonding strength. • UV treatment yields 10% higher bonding strength than laser-texturing. • The adhesion of UV treated samples exceeded the CFRP interlaminar strength. • UV treatment reduces CFRP surface WCA from 90° to 20°. • Combined IR laser & UV treatment has small gain over single laser treatment. The preparation of Carbon Fibre Reinforced Polymers (CFRP) surfaces for adhesive bonding has been widely reported. Such reports include laser texturing using both near-infrared (IR) lasers and ultraviolet (UV) lasers. In this report, we present, for the first time, findings showing that surface treatment of CFRP using incoherent UV light, at 254 nm wavelength, can increase the adhesive bonding strength of CFRP by 75 % compared to non-treated samples. It is also around 10 % stronger than NIR laser-textured samples. However, combination treatments, where the UV irradiation is conducted either before or after laser texturing did not give a significant benefit over the laser-textured samples. A germicidal 46 W 254 nm UV lamp was used for the UV light treatment, while an IR nanosecond pulsed fibre laser operating at 1064 nm was used for the laser texturing treatment. The material tested was an autoclave-cured T700 CFRP composite. The wettability of the treated CFRP surfaces and the adhesive bonding were quantitatively assessed. This study concludes that low-cost incoherent UV treatment effectively reduces the water contact angle of the CFRP surface and activates CFRP surfaces. All treatments led to bonding strengths at least 50% greater than for the untreated surfaces. The predominant failure mode for UV-treated samples was Cohesive Substrate Failure (CSF), indicating that the adhesion strength exceeded the interlaminar shear strength of the CFRP material. All samples treated with the laser (including combined treatment with UV) exhibited Light Fibre Tear Failure.