Slab Segmentation and Stacking in Mantle Transition Zone Controls Disparate Surface and Lower Mantle Subducting Rates and Complex Slab Morphology

Abstract The contradiction of high subducting plate rate (ranging from 4 to 9 cm/yr on Earth's surface) and low slab sinking rate (about 1 and 2 cm/yr in lower mantle) calls for significant slab deformation in the middle mantle. However, mechanisms that can account for both the deformation and the rate discrepancy have not been fully explored. Here, using 2‐D numerical models that incorporate grain size evolution, we propose a new slab deformation mode, slab segmentation and stacking, to accommodate the differential slab sinking rates. Our results show that the segmented slab due to faulting and grain‐size reduction may further break off and stack over itself as it encounters the high‐viscosity lower mantle. Stacked slabs slowly sink in the lower mantle, while periodic slab tearing hinders upward stress transmission, allowing shallow plates to subduct at a higher rate. This discovered mode also provides an alternative explanation for slab thickening in the lower mantle.