The effect of sodium chloride on the charge state of soot particles in a laminar diffusion flame

• The study focuses on soot particle charge state and how soot evolves in flames. • The impact of NaCl on methane flame was investigated. • A well-studied Santoro burner was utilized to produce a stable laminar diffusion flame. • A charging model was employed to estimate the impact of NaCl on ion concentrations. • Soot particle size and formation differ between methane and methane-NaCl flames. This study investigates the effect of sodium chloride on the charge state of soot nanoparticles formed in a laminar diffusion flame by measuring the soot particle size distribution, average charge per particle, and charge fraction at various heights within the flame. The well-studied Santoro burner with methane as the fuel (at 0.35 L/min) and co-flow air (at 70 L/min) was used, which produced a stable laminar diffusion flame with flame height of 61 mm. Samples of soot nanoparticles were extracted via a 0.3 mm orifice in a 3-mm stainless steel tubular probe at various heights above the burner and were immediately diluted by a factor of a few thousand for aerosol measurement. The effect of sodium chloride on a methane flame was investigated by comparing the experimentally measured data for methane-only and methane-NaCl flames. The addition of NaCl particles to the laminar diffusion flame did not have a significant effect on the particles in the nucleation region of the flame. The majority of the incipient soot particles in both flames are uncharged, and their sizes are nearly the same, with diameters of approximately 5 nm or less. However, the size of soot particles differs by approximately 10 % to 25 % between methane-only and methane-NaCl flames in the coagulation-dominated region of the flame. The net charge on soot particles within the coagulation region of the methane-only flames is negative, while it is positive with NaCl addition. The fraction of charged particles and ion concentration decreases with NaCl addition within the coagulation region. The study indicates that the smaller particle size observed in methane-NaCl flames may be attributed to reduced coagulation via altered particle charge states. These factors could be the major contributor to the variations in soot formation between methane-only and methane-NaCl flames. This research addresses a notable knowledge gap concerning the influence of NaCl, a prevalent component of hydraulic fracturing fluids, on soot particle behaviour in flames. By explaining the impact of NaCl on soot formation and charge states, the findings contribute to a deeper understanding of combustion processes in environments influenced by hydraulic fracturing operations, thereby informing strategies for reducing emissions and improving environmental sustainability in energy production. Overall, this article represents a significant advancement in the field of combustion science, with implications for environmental stewardship in energy production. This study provides valuable insights into how the introduction of NaCl alters the electrostatic properties of soot particles. This investigation expands upon existing knowledge by shedding light on the intricate mechanisms underlying soot formation and evolution in the presence of NaCl, elucidating its potential implications for combustion processes involving fossil fuels and industrial flaring.