An experimental validation study of a numerical modeling approach to predicting post-consolidation dimensions of thermoplastic composites

Consolidation is an important step in the processing of thermoplastic unidirectional (UD) tapes, as it creates a bond between individual tapes to form a semi-finished sheet: The tape stack is first heated and then cooled, both while being subjected to pressure. If the material is in a soft or even molten state and its flow unrestricted, this compression can result in squeeze flow, the direction of which is determined by the fibers of the tapes. Extensive squeeze flow not only results in significant changes in part geometry to the point where it may fail to meet design and application specifications but can also lead to severe distortion and residual stresses. To address this, we developed a model that, given the process parameters and fiber orientation, predicts the effects of squeeze flow. Based on experimental data on UD polycarbonate tapes with 44% carbon fibers by volume consolidated at various process settings, this paper presents the validation of the model for industrial application. We found that at low heating temperatures, where the matrix viscosity is too high and prevents the material from flowing, the simulation results deviated markedly from the experimental data. With these temperatures excluded, however, the overall deviation of the model was 8.7% for thickness change and 5.3% for area change.