A High-Temperature, High-Speed, Oil-Free Syngas Compressor for Small-Scale Combined Heat and Power

Abstract For low-emission, small-scale combined heat and power generation, integrating a biomass gasifier with a downstream solid oxide fuel cell system is very promising due to their similar operating conditions in terms of temperatures and pressures. This match avoids intermediate high-temperature heat exchangers and improves system efficiency. However, to couple both systems, a high-temperature and oil-free compressor is required to compress and push the low-density, high-temperature biosyngas from the gasifier to the solid oxide fuel cell stack. The design and development of this high-temperature, high-speed, and gas-bearing supported compressor is presented in this work. A holistic iterative process involving preliminary design, meanline analysis using commercial tools and in-house models is used for the design, which is then numerically analyzed using computational fluid dynamics. The goal is to achieve a design with a wide operating range and high robustness that withstands extreme working conditions. The 727 W machine is designed to run up to 210 krpm to compress 18.23 kg h−1 of syngas at 350 °C and 0.81 bar. The centrifugal compressor has a tip diameter of 38 mm and consists of 9 backswept main and splitter blades. The impeller is made of Ti6Al4V and coated to prevent hydrogen embrittlement from the hot and highly reactive biosyngas. The results obtained from the established models suggest a good concordance with the results from numerical analyses, despite the high temperatures and small scale of this design.