Stability enhancement using a new combined casing treatment strategy in an ultra-highly loaded transonic compressor rotor

• Enhanced stability for ultra-high-load transonic rotors via tailored casing treatment strategy. • Insights into stall mechanism shifts post-casing treatment. • Revealed unsteady mechanisms to suppress unstable flow structures. • Stall margin is extended by approximately 12 %. Low-reaction compressors are promising for achieving high loads but face severe flow instability challenges. This study investigates a low-reaction transonic compressor rotor using casing treatment technologies to control unstable flow dynamics precisely. First, a design integrating self-recirculating and circumferential groove casing treatments near the leading edge is implemented. This design enhances flow capacity at the tip passage inlet. However, it causes a “stall transposition” phenomenon. The unstable flow structures shift from shock-tip leakage vortex interactions at the front to corner separation at the rear. Consequently, the stall mechanism transitions from an end-wall stall to a blade stall. To address this issue, a new casing treatment layout is proposed. Grooves are added after the mid-chord of the initial front casing configuration. This adaptation suppresses emerging unstable flow structures and extends the stall margin by approximately 12.07 %. Detailed flow field analysis shows that the rear grooves effectively reduced the trailing edge separation vortex. They also limit downstream corner separation and mitigate disturbances from tip leakage flows in the rear of the passage.