Monitoring performance of a new smart geosynthetic under drawing test

Geosynthetics are widely used in civil engineering reinforcements owing to their high strength, acceptable toughness, and ease of transportation. However, traditional geosynthetics do not have the capability to monitor damage inside the soil. Therefore, in this paper, a new sensor-enabled piezoelectric geobelt (SPGB) is developed to measure the deformation of reinforced-soil structures. In-soil drawing tests are conducted to investigate the sensing performance of the SPGB. Variations in the voltage and impedance signals of the SPGB with the drawing displacement under different damage conditions are investigated. The results show that with the increase of drawing displacement, SPGB undergoes tensile deformation followed by pullout damage. In tensile deformation, the signal response of SPGB is related to strain. As the strain increases, the output voltage first increases and then decreases, and the impedance gradually decreases. In the pullout damage phase, the signal response of SPGB is related to the contact area between SPGB and soil. As the drawing displacement increases, the contact area between SPGB and soil gradually decreases, the output voltage gradually decreases, and the impedance gradually increases. Therefore, the SPGB, as a sensor-enabled geosynthetic, provides a reinforcing function to the soil body and simultaneously performs in-soil catastrophe identification.