Investigating the Feasibility of EOR While Preloading Parent Wells to Mitigate Fracture Hits: An Experimental and Modeling Study

Summary During a fracturing operation in an infill (child) well, pressure and fluid communication between this well and a nearby parent well, known as fracture hits (FHs), can impair the production performance of both wells. A cost-effective strategy to mitigate the FH is to preload the parent well with water during the fracturing of the child well. It has been hypothesized that the production performance of the parent well can be enhanced by the preloading process if proper additives are used in the injected water. We develop a laboratory protocol to physically simulate primary production and surfactant preloading stages using Montney core and fluid samples under reservoir conditions. We investigate the role of wettability alteration, interfacial tension (IFT) reduction, and surfactant’s chemical stability on the performance of enhanced oil recovery (EOR) during the preloading process. An analytical model is developed to predict the volume of leaked-off surfactant and recovered oil using measured pressure-decline data from the preloading stage. This study only focuses on the interactions of preloading fluid with the parent well’s matrix and does not consider the child-parent well interference. Our results demonstrate that 31.8% of the oil is recovered during primary production from large inorganic pores under solution-gas drive mechanism. Under countercurrent imbibition, a nonionic surfactant leaks off into the smaller organic and inorganic pores and recovers an additional 11.8% oil from a depleted core during preloading. The analytical model estimates oil recovery factors close to the experimental data determined by material balance. Core visualizations demonstrate a population of small oil droplets on the rock surface under reservoir conditions. While IFT is reduced to nearly the same extent by either surfactant, only the wettability-altering surfactant yields incremental oil recovery. Zeta-potential measurements indicate that while neither surfactant alters the rock-water surface charge, the wettability alteration is achieved by modifying the oil-water surface charge even at concentrations above the critical micelle concentration (CMC). Based on the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory, the repulsive electrostatic double-layer (EDL) forces are intensified with an increase in surfactant concentration, resulting in enhanced stability of the water film on the rock surface and increased hydrophilicity. Under elevated temperatures, we observe two phenomena, which can adversely affect the performance of a nonionic surfactant: (a) agglomeration of surfactant particles due to reduced solubility in water, reducing pore accessibility, and (b) chemical decomposition of the surfactant, affecting its ability for IFT reduction and wettability alteration.

Authors

Institutions

Publication Details

Journal
SPE Journal
Published
2024-08-23
DOI
https://doi.org/10.2118/223093-pa
Citations
4
Primary Topic
Hydraulic Fracturing and Reservoir Analysis
Type
article
Field-Weighted Citation Impact
0.85
Controls
|||
ALL TIME
JAN
FEB
MAR
APR
MAY
JUN
JUL
AUG
SEP
OCT
article

Investigating the Feasibility of EOR While Preloading Parent Wells to Mitigate Fracture Hits: An Experimental and Modeling Study

Hassan Dehghanpour, Amin Alinejad
4 citations
SPE Journal
Hydraulic Fracturing and Reservoir Analysis
0.85
article

Investigating the Feasibility of EOR While Preloading Parent Wells to Mitigate Fracture Hits: An Experimental and Modeling Study

Hassan Dehghanpour, Amin Alinejad
article en
4 citations

Abstract

Summary During a fracturing operation in an infill (child) well, pressure and fluid communication between this well and a nearby parent well, known as fracture hits (FHs), can impair the production performance of both wells. A cost-effective strategy to mitigate the FH is to preload the parent well with water during the fracturing of the child well. It has been hypothesized that the production performance of the parent well can be enhanced by the preloading process if proper additives are used in the injected water. We develop a laboratory protocol to physically simulate primary production and surfactant preloading stages using Montney core and fluid samples under reservoir conditions. We investigate the role of wettability alteration, interfacial tension (IFT) reduction, and surfactant’s chemical stability on the performance of enhanced oil recovery (EOR) during the preloading process. An analytical model is developed to predict the volume of leaked-off surfactant and recovered oil using measured pressure-decline data from the preloading stage. This study only focuses on the interactions of preloading fluid with the parent well’s matrix and does not consider the child-parent well interference. Our results demonstrate that 31.8% of the oil is recovered during primary production from large inorganic pores under solution-gas drive mechanism. Under countercurrent imbibition, a nonionic surfactant leaks off into the smaller organic and inorganic pores and recovers an additional 11.8% oil from a depleted core during preloading. The analytical model estimates oil recovery factors close to the experimental data determined by material balance. Core visualizations demonstrate a population of small oil droplets on the rock surface under reservoir conditions. While IFT is reduced to nearly the same extent by either surfactant, only the wettability-altering surfactant yields incremental oil recovery. Zeta-potential measurements indicate that while neither surfactant alters the rock-water surface charge, the wettability alteration is achieved by modifying the oil-water surface charge even at concentrations above the critical micelle concentration (CMC). Based on the Derjaguin-Landau-Verwey-Overbeek (DLVO) theory, the repulsive electrostatic double-layer (EDL) forces are intensified with an increase in surfactant concentration, resulting in enhanced stability of the water film on the rock surface and increased hydrophilicity. Under elevated temperatures, we observe two phenomena, which can adversely affect the performance of a nonionic surfactant: (a) agglomeration of surfactant particles due to reduced solubility in water, reducing pore accessibility, and (b) chemical decomposition of the surfactant, affecting its ability for IFT reduction and wettability alteration.

SPE JournalVol. 29(11)
University of Alberta (CA), University of Petroleum (ID)
Clean water and sanitation
Openalex Percentile: Top 31%
Hydraulic Fracturing and Reservoir Analysis
0.85
AI Navigator

Ask Laika to Summarize, Analyze, and Connect papers live on the map.

Summarize Papers & Methodologies

Extract key findings, datasets, and comparative methods across publications.

Benchmark Rankings & Visual Analytics

Rank top research institutions, authors, funders, topics, and journals by Field-Weighted Citation Impact (FWCI) and paper volume with instant charts.

Connect Distant Disciplines

Bridge topological clusters on the map to find hidden collaborative intersections.