C60/CZTS Junction Combination to Improve the Efficiency of CZTS-Based Heterostructure Solar Cells: A Numerical Approach

This work presents a copper zinc tin sulfide (CZTS)-based solar cell structure (AI/ITO/C60/CZTS/SnS/Pt) with C60 as a buffer layer, developed using the SCAPS-1D simulator by optimizing each parameter to calculate the output. Optimizing the parameters, the acceptor concentration and thickness were altered from 6.0 × 1015 cm−3 to 6.0 × 1018 cm−3 and 1500 nm to 3000 nm, respectively. Although, in this simulator, we can tune the value for the acceptor concentration to 6.0 × 1022, higher doping might present an issue regarding adjustment in the physical experiment. Thus, tunable parameters need to be chosen according to the reliability of the experimental work. The defect density varied from 1.0 × 1014 cm−3 to 1.0 × 1017 cm−3 and the auger hole/electron capture coefficient was determined to be 1.0 × 10−26 cm6 s−1 for the maintenance of the minorities in theoretical to quasi-proper experimental measurements. Although the temperature was intended to be kept near room temperature, this parameter was varied from 290 K to 475 K to investigate the effects of the temperature on this cell. The optimization of the proposed structure resulted in a final acceptor concentration of 6.0 × 1018 cm−3 and a thickness of 3000 nm at a defect density of 1.0 × 1015 cm−3, which will help to satisfy the desired experimental performance. Satisfactory outcomes (VOC = 1.24 V, JSC = 27.03 mA/cm2, FF = 89.96%, η = 30.18%) were found compared to the previous analysis.