Neural Network-Based Aggregated Equivalent Modeling of Distributed Photovoltaic External Characteristics of Faults

Distributed power networks have a large number of photovoltaic power sources. The bidirection of power flow, different transient control strategies, and installation locations make the transient characteristics highly complex and unpredictable. The vast network of the distribution system makes it almost impossible to predict the electrical quantities of each branch. Reasonable aggregation modeling of the distribution network can greatly simplify the network topology, facilitating transient control and the setting of relay protection settings. An aggregated equivalent modeling method based on the LSTM neural network for distributed PV fault external characteristics is proposed. This method equates the complex distribution network to a highly nonlinear but controllable current source. The method can output the I–V curves of equivalent PV system parallel points under any output power and is able to predict the fault characteristics of the equivalent system after a voltage drop at the parallel point. Compared to traditional mechanistic modeling, this method does not require specific modeling of complex physical systems and is able to accurately map the strong nonlinear inputs and outputs of distribution networks. The established LSTM model first uses a one-dimensional convolutional layer for feature extraction of the PV power coefficients (input), and then two hidden layers are utilized to process the sequence data; the vectors are mapped into a sequence of external characteristic curves (output) in a fully connected layer. A typical distribution network is built based on the traditional PV power model, and a large number of different output combinations are selected for simulation to provide an effective training set and validation set data for LSTM model training. By using the training set data, the weights and offset coefficients of each layer of the LSTM are continuously optimized until the model with the smallest overall error is obtained, which is the optimal model. Finally, the optimal model is utilized to establish an equivalent distribution network system, different degrees of voltage drops are set up at the grid-connected points, the fault characteristics are compared with those of the complete model, and the simulation results can prove the reliability and practicality of the proposed method.