Laboratory investigation of the influence of fines content on the mechanical behavior of sand

The present article seeks to examine and discuss the experimental results that were obtained from a series of straight box shear tests. For this, different soils were prepared with clean sand, which was brought from the Wilaya (Province) of Chlef that is located in northern Algeria, mixed with silt from the same site, clay from the town of M'zilla or clayey loam that is composed half of this same clay and half of silt. The percentages of sand replacement by the selected additions were 0, 10, 20, 30, and 40% in mass ratio. The samples thus prepared were then tested with respect to dry shear, under the normal stresses equal to 100, 200, and 400 kPa. The results obtained showed that the shear strength of the sand from Chlef decreases when the silt content increases from 0 to 40%. With regard to the sand-clay and sand-silt-clay mixtures, it was found that the shear strength decreases until reaching a threshold value that coincides with the addition content of 20%. Then, beyond that value, it begins to increase as the addition fraction increases. Likewise, it turned out that cohesion increases with increasing silt content, while for sand-clay and sand-silt-clay mixtures, this cohesion increases until reaching a maximum value which coincides with the addition of 20% silt content. The same trend was observed for the variation of the direct shear strength, while the friction angle exhibited an inverse behavior.