Enhanced mechanical, corrosion, and tribological properties of hydroxyapatite coatings for orthopedic and dental applications

Biomedical coatings were elaborated by pulsed electrodeposition with hydrogen peroxide (H 2 O 2 ) into electrolytes on Ti 6 Al 4 V substrates, and the effect of H 2 O 2 concentration on the electrolyte and the heat treatment was studied. The experimental procedures employed in this study produce a consistent hydroxyapatite coating. This coating is well-suited for use in bio-implants, as it enhances the integration of the implant with surrounding bone tissue and improves the mechanical performance. The coatings' surface morphology and chemical composition were assessed using scanning electron microscopy (SEM) in conjunction with energy-dispersive X-ray spectroscopy (EDXS) for x-ray microanalysis. X-ray diffraction (XRD) was also utilized to identify the phases and composition of the coatings. Nanoindentation and scratch tests were conducted to analyze the nanomechanical properties and adhesion behavior. Potentiodynamic polarization was employed in the Ringer solution to evaluate the corrosion resistance and replicate the conditions of the human body environment. The results of our thorough investigation revealed that employing pulsed electrodeposition with 9 % H 2 O 2 in the electrolyte, combined with subsequent heat treatment, facilitated the creation of coatings comprising two distinct phases: stoichiometric hydroxyapatite (HAP) and β-tricalcium phosphate (β-TCP). Our meticulous research underscores the significance of this process in achieving these specific coating compositions. Under these tests listed above, this composite demonstrated favorable mechanical properties (E = 30.45 GPa and H = 72.2 MPa). It also exhibited superior scratch adhesion and a critical load of 23 MPa and 12 N, respectively. Additionally, an improvement in tribological comportment was observed, and the wear volume decreased from 4.15 10 6 μm 3 to 2.44 10 6 μm 3 . The HAP coating heat treated with 9 % H 2 O 2 exhibited the highest corrosion resistance, with E corr at −0.189 V/SCE and i corr at −1.11 μA cm −2