Induction heating simulation for aircraft RTM toolings

Aircraft CFRP parts as sharklets are produced in resin transfer molding (RTM) tooling. The parts need to be heated up homogenously over the whole area with a constant temperature. The complex shape and accessibility of the tooling make it hard to introduce a common heating system. In addition, the heat must be transferred through the Invar metal tooling structure onto the CFRP. Infrared lamp, air fan and microwave heating are concepts in development. Electrical heating layer mats and cages are laborious in applying. Induction has the advantage of contact-less, efficient, and fast heating. Induction heating was tested for the structural bonding of CFRP frames and stringers showing high bonding strengths. To apply this technology for the RTM tooling, the placement and distance of the induction coils is important. Simulation can help to find the right adjustments and power needed for induction heating. With the program COMSOL the surface and the coils are modeled, and the numerically structured net is divided in small tetrahedron and quadratic sub elements. Since there is no magnetic streamline in the middle of the coil-section, a symmetric halving of the structure is applied as a boundary condition. The temperature-time development and the distance of the coils are simulated in 2D and 3D. Due to the material properties of the magnetic flux concentrator (MFC), higher flux concentration of the magnetic field occurred only in 2D. The results are validated by experiments and are in good agreement.