Dead-Time Free Modulation Scheme for IM Drive System Fed by Voltage Source Inverter

During the modulation process of the VSI motor drive system, the nonlinear errors caused by the dead-time and conduction voltage drop will increase the phase current harmonic distortion and the torque ripple. To solve this problem, a novel dead-time free modulation scheme is proposed in this paper. In the non-zero crossing region of the phase current, the switching tube, whose body diode can provide a continuation path, is set as off-state, the driving signal is only implemented on another switching tube with the same bridge arm, and the errors caused by the conduction voltage drop and switching delay are compensated to the pulse duration. At the same time, to suppress the zero current clamp effect that exists near the zero crossing point of the phase current, another modulation scheme for the phase current crossing zero in advance is proposed, which avoids the complicated determination and calculation of the current polarity near the zero crossing point of the current. Both of the above modulation schemes eliminate the dead-time, and the switching principle is presented. In addition, to suppress the impact of the current ripple and high-frequency noise on the accuracy of the phase current detection, a second-order resonance digital filter without phase shift is introduced. Finally, compared to two deadtime compensation methods, the effectiveness and superiority of the proposed dead-time free modulation scheme are verified by the experimental results.