Effect of Swing Amplitude on Microstructure and Properties of TC4 Titanium Alloy in Laser Welding

The welding of TC4 titanium alloy sheets with a thickness of 1 mm was successfully accomplished by a swinging laser. The microstructure and mechanical properties of the welding seam under different swing amplitudes were studied. In this paper, the microstructure, phase composition, mechanical properties, and fracture morphology of the weld with swing frequency of 50 Hz and different swing amplitudes (0.2 mm, 1 mm, 2 mm, and 3 mm) were tested and analyzed. The results show that basket-weave microstructures are present in the fusion zone of welds under different oscillation amplitudes, but the morphology of martensite within the basket-weave differs. The weld microstructure is mainly composed of acicular α′ martensite, initial α phase, secondary α phase, and residual β phase. The hardness of the weld is higher than that of the base metal, and the overall hardness decreases from the weld center to the base metal. When the oscillation amplitude A = 1 mm, the weld microstructure has the smallest average grain size, the highest microhardness (388.86 HV), the largest tensile strength (1115.4 MPa), and quasi-cleavage fracture occurs. At an oscillation amplitude of A = 2 mm, the tensile specimen achieves the maximum elongation of 14%, with ductile fracture as the dominant mechanism.